We have the video, but here is not allowed to show, pls sent us message, we will sent you the video link

What is HUD:

1.      Speed: Number indicates the current speed.

2.      Rotation speed: indicates the rotating status of the engine and the scale measured represents the speed reached.

3.      Water temperature: When the temperature reaches 115 degree centigrade, alarm will be given automatically with alarm light turned on.

4.      Tips for shifting gear: It will indicate to gear up to save fuel when the engine speed and car speed come to a certain ratio.

5.      Tips for over speed: It will flicker and alarm when exceeding the speed limit set up before.

6.      Immediate one hundred kilometers/instantaneous fuel consumption: Display fuel consumption of one hundred kilometers when there is speed, in L/100km.

7.      unit of kilometer: In the international system of units, kilometer/hour is commonly used, in km/h.

8.      Battery voltage: when the battery voltage is less than/reaches 12v, the caution light will light up to remind.

9.      Buzzer mark: press the switch button can turn on or turn off the sound of the buzzer.

10.    Auto wake up host,  the unit will turn on when the engine start .  And  auto standby when the            engine off

11.   Auto adjustment on HUD display brightness , bright in day time and not dazzling in night time

12.   Voltage High or Low alarm

13: Water Temperature High Or Low alarm

14:  Fault Code monitoring and alarm

 

Preparation before installation and use

1.    Know the type of your vehicle. When purchasing HUD, you need to choose the type of vehicle that meets the OBDII standards for normal use. Open the engine hood and find the paster below it (see the picture below), if it has words like OBDII CERTIFIED, then it can be installed. Check if there is a test diagnostic communication link (TDCL) under the steering wheel. (Most of the vehicles after 2006 in China have been equipped with a TDCL)

 

2.    Find out the diagnostic link (see the picture below) of vehicle 16 pin and connect it well with OBDII connecting line. As different types of vehicles have different positions for diagnostic link and some are relatively narrow, patch cord can be purchased.

3.  Put the give-away non-slip mat at the flat place in front of the navigation bridge, then you can place the host machine of HUD on it and adjust its location at any time.

4.  The reflecting film should be pasted right above the H101 host machine and it should be able to reflect the mainframe screen.

Methods of pasting the film:

A . equably water the place that the film will be pasted on ;

B . rip off the covering layer of the film , and water both sides of it , and paste it to the right place.

C.  After you have adjusted the location well, you can use a scratch board or something else flat to slick the film and squeeze the water inside out until there is no bubble or water in it.

D.  A few minutes later, the moisture inside the film totally evaporates , then you can finish this by wiping away the water and dust around .

 

Accessories of product

Host machine of HUD  .................................................................... ×1

Reflecting film................................................................................. ×1

OBD connecting line........................................................................ ×1

instruction book............................................................................... ×1

non-slip mat..................................................................................... ×1